The Bullet pumps are ideal for dewatering constructions sites, mines, circulating fountain water, or for all around use in industrial plants and utilities.

Top Discharge – allows for superior cooling of motor and provides a slim line design.

Longer Power Cord – Standard 33ft. power cord on pumps ½ HP and below and 50ft. on pumps 1HP and above.

304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.

Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic*. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.

More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.

Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components*.

R400D Special Feature – The mode Up Pumps, will pump down to 1/12 th of an inch. It features a special diaphragm value that prevents water backflow.

(click image to enlarge)

Quick Overview

The R100 is ideal for many applications such as light dewatering, pool covers, sump pump applications, and can be used in salt water. It offers features that are normally on larger, more expensive pumps. The motor is protected by a heavy duty mechanical seal made of silicon carbide and a lip seal made of oil resistant Buna. The rotor shaft, motor housing and all hardware are made of 304 stainless steel. All other “wet parts” are made of reinforced plastic. A thermal breaker ensures shut-down should overheating occur.

Recommended accessories

Piggy Back type float switch (115 Volt w/ plug):

30’ Cable, 115 Volt = BJM Item # 201050
50’ Cable, 115 Volt = BJM Item # 201060

Side Mount Vertical Rod Type Float Switch:

30’ Cable, 115 Volt = BJM Item # 201051

Built-In Switch (Permanently attached to pump):

33’ Cable (115 Volt) = BJM Item # 201724
50’ Cable (115 Volt) = BJM Item # 201725

Simplex Control Panel - (3 mechanical float switches):

Single Phase Control Panel for R100-115 = BJM Item # 201069

Duplex Control Panel - (4 mechanical float switches):

Single Phase Control Panel for R100-115 = BJM Item # 201074

Interested in this item or want more information?
8:00 & 5:00 PST
Phone: 657-777-3411
Email: sales@48ws.com

Can't find what you want? Give us a call and we can help you find it.

Details

GENERAL DATA