• Max. Flow: Gpm: 1690
• Max. Head: Ft: 77'
• Pump Type: Slurry
• Strainer Opening: 1.375"
• Discharge Size: 6" NPT-M (8" flange optional)
• Discharge Connection: 6" or 8" Hose Barb Optional
• Max. Submerged Depth: 65'
• Shipping Weight:Lbs: 1275

• Motor Casing: Cast Iron
• Pump Volute: Ductile Iron
• Impeller - Multi Vane: Hi-Chrome
• Lip Seals & O-Rings: Buna - N
• Rotor Shaft: 410 SS
• External Hardware: 304 SS
• Qty. Oil In Seal Chamber: 213 U.S. FL OZ.

• Motor Rating: Hp: 30
• Motor Rpm: 1750
• Motor Insulation Class: H
• Motor Service Factor: 1.15
• Voltage: 460/575, 3ph-60Hz
• Motor Protection: Thermal & Amp Overload
• Power Cord: Gage; Length: A.W.G 4/5; 50', SOOW
• Maximum Liquid Temperature: 104° F
• Seal Minder: Optional

KZN Heavy Duty Submersible Slurry Pumps with agitator is the choice of industries that face the most difficult pumping

TOP 3 REASONS WHY YOU SHOULD CHOOSE THE KZN…

1. EVERY KZN slurry pump is constructed with the following abrasive resistant 28% chrome iron (600 Brinell, 57 Rockwell C) components;
• Agitator - to fluidize settled solids into a slurry.
• Wear plate - replaceable hardened surface on the suction side where erosion would cause a loss of pump performance.
• Semi - open Impeller - to handle abrasive solid concentrations as high as 70% by weight.


2. EVERY KZN slurry pump model is protected by;
• Class H motor insulation - and built in amperage ( FLA ) and temperature overload protection.
• Double silicon carbide mechanical seals - in a separate oil filled seal chamber.
• Heavy Duty Lip Seal – additional protection for the mechanical seals.Stainless steel shaft and shaft sleeve – saves on shaft wear due to abrasives and corrosion.
• Pump volutes cast from hardened Ductile Iron - 300 Brinnell hardness; twice as abrasive resistant as standard ductile iron.


3. EVERY KZN is a top discharge pump;
KZN heavy duty slurry pumps are utility pumps; frequently dragged from one site to another. The KZN doesn’t have a side discharge connection that can break off or be damaged as it is pulled and pushed into place.
• Top discharge pumps are cooled by pumped liquid - The KZN slurry pumps can pump a sump or pit down to within "inches" of the bottom. A side discharge pump without a cooling jacket must stay submerged to avoid overheating, leaving as much as 3 feet of un-pumped slurry.
• Top discharge means "SLIM" - even the largest model with a 22.75 inch "waistline" will fit down a manhole with a hose attached.
• The KZN’s hardened ductile iron volutes - cast with extra thick walls at the point where pumped slurry enters the discharge.