• Max. Flow: Gpm: 330
• Max. Head: Ft: 69'
• Pump Type: Open Vane Non Clog
• Discharge Size: 3" flange w/ 4" NPT-F discharge (3" NPT-M optional)
• Max. Submerged Depth: 65'
• Min. Submerged Depth: 15"
• Shipping Weight:Lbs: 130

• Motor Casing: 304 SS
• Pump Volute: Cast Iron
• Strainer / Stand: Cast Iron
• Lip Seals & O-Rings: Buna-N
• Rotor Shaft: 304 SS
• External Hardware: 304 SS
• Qty. Oil In Seal Chamber: 11.8 U.S. FL. OZ.

• Motor Rating: Hp: 5
• Motor Rpm: 3450
• Motor Insulation Class: F
• Motor Service Factor: 1.1
• Voltage: 208/230/460/575, 3PH-60 Hz
• Current F.L.A.: 14.7
• Motor Protection: Thermal & Amp Overload
• Power Cord: Gage; Length: A.W.G. 12/4; 33', STOW
• Maximum Liquid Temperature: 104° F
• Seal Minder: Standard/Included

Electric Submersible Pumps with Single Vane Impellers for Municipal, Industrial and Agricultural Waste-Water

The S-pumps have non-clog, single vane impellers designed for high volume and lift performance.

• Longer Power Cord – Standard 33ft. power cord.
• 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
• Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
• More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
• Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.