• Max. Flow: Gpm: 185
• Max. Head: Ft: 46'
• Pump Type: Non Clog Shredder
• Discharge Size: 3" NPT-M
• Max. Submerged Depth: 65'
• Min. Submerged Depth: 14"
• Shipping Weight:Lbs: 100

• Motor Casing: 304SS
• Pump Volute: Cast Iron
• Strainer / Stand: Cast Iron
• Lip Seals & O-Rings: Buna-N
• Rotor Shaft: 304SS
• External Hardware: 304SS
• Qty. Oil In Seal Chamber: 7.8 U.S. FL. OZ., SHELL FM 32, NSF APPROVED
• Qty. Oil In Motor Stator: OIL-FILLED W/ SHELL FM 32, NSF APPROVED

• Motor Rating: Hp: 2
• Motor Rpm: 3450
• Motor Insulation Class: R
• Motor Service Factor: 1.1
• Voltage: 230, 1PH-60 Hz
• Current F.L.A.: 14
• Motor Protection: Thermal Sensor Switches Embedded in Each Winding Phase
• Power Cord: Gage; Length: A.W.G. 14/4; 33', high temp. rated
• Maximum Liquid Temperature: 200° F
• Seal Minder: Standard

The Shredder (SKF) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate.

• Longer Power Cord – Standard 33ft. power.
• 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
• Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
• More Motor Protection – Winding protection and (NEMA) Class R motor insulation with a thermal cut out switch that will allow the stator to have a winding temperature of up to 300 degrees F (150 C), superior to pumps with Class A and B insulation.
• Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.