ProRoc Wall and Ceiling Spray Textures provide a decorative appearance over gypsum panels and most other interior wall and ceiling surfaces. They are formulated to provide for a variety of decorative options including splatter, knockdown and orange peel designs.
MIXING: Use a clean vessel equipped with powder agitator. For initial mix, stir powder into recommended amount of water agitating during powder addition. Allow to soak for at least 15 minutes. Remix until creamy, lump free mix is obtained. Adjust spray consistency by adding small amounts of water, if necessary. Over thinning can create an undesirable finish, “soft wall” or chalky condition. Over dilution can also entrain excessive air and foam. Note that the air and mix temperature will affect viscosity.
APPLICATION: Texture should not be applied until the primer coat is thoroughly dry. Products are specifically designed for spray application. The desired pattern can be achieved by varying the viscosity of the mix, the orifice opening at the spray tip, or the air supply pressure.