Details

SPEC-SEAL WB is a water-based acrylic sealer. SPEC-SEAL WB is designed for use over decorative concrete, properly prepared concrete floors, pool decks and other new or old concrete and masonry surfaces. SPEC-SEAL WB is breathable, will not blush or yellow and dries quickly to a satin appearance. It has good chemical resistance, hot tire pickup resistance and will resist discoloration from dirt and spills. SEC-SEAL WB protects substrates treated with water-based or acid stains.

COVERAGE

Porous Surface : 100-300 sq.ft./gal. Dense Concrete : 400-600 sq.ft./gal.

APPLICATION

On cured concrete apply Spec-Seal WB only when the air and surface temperatures are between 50° and 90°F. On hot dry days, apply during the cooler part of the day when the concrete is shaded; in some cases overnight surface cooling is necessary. Do not apply during inclement weather, when rain is expected or in direct sunlight when temperatures exceed 80°F. Spec-Seal WB can be applied with most types of pump-up spray equipment, synthetic bristle brush, 3/8" or 1/2" nap roller, microfiber mop, or airless sprayer with a 0.013"-0.015" tip size. Application to a damp surface or non-completely cured concrete may cause a hazy appearance or loss of adhesion. Apply Spec-Seal WB uniformly and thinly at the recommended rate under Coverage. The sealer will appear milky when wet, but will dry clear. On porous concrete (broom finish, most imprinted surfaces), paver brick, flagstone, etc. generally one coat will provide complete protection. A second coat will provide added protection and a higher sheen. If a second coat is desired, apply as soon as the first coat is dry to the touch. On dense concrete (hard troweled), slate, stone, etc. one light coat provides complete protection. It is not recommended to apply more than one coat on a dense surface.

• Spec Data Sheet (Application and Technical Data)  [Click Here]


• Material Safety Data Sheet  [Click Here]

Additional Information

Manufacturer: Spec-West Concrete Systems